IR Channel Changing

Please follow the steps below to verify that cable and transceiver (also called “IR blaster”) are used correctly to send signals from Nero LiquidTV™ | TiVo® PC to your cable or satellite box.
These signals allow Nero LiquidTV™ to change channels on your cable or satellite box.

Step 1:
Verify that the IR cable is connected to your PC.

Step 2:
Make sure the emitter at the other end of the cable is positioned so that the IR signal can reach the IR sensor of the box. You may need to experiment until you find the best location.

If you have verified that the IR cables are correctly connected, but still have trouble changing channels, see How do I Change Channels Using IR Control?.

Perform the following steps to configure your Nero LiquidTV™ to control your cable or satellite box:

→ You can set up IR control either during or after completing the Guided Setup.

If you are currently in Guided Setup, start with Step 5.

Begin here if you are not in the Guided Setup:

Step 1:
Go to the Channel Changing screen on your Nero LiquidTV™. From TiVo Central® select Messages & Settings; then Settings; then Channels; then Channel Changing.

Step 2:
You will receive a warning message on this screen indicating that programs will not record while you are changing this setting.

→ Choose OK, Access This Setting.

Step 3:
Next, you will be asked if you still have the same cable or satellite box. Answer that question appropriately. If you are using the same satellite or cable box, continue with Step 4. If you have a new cable or satellite box, you will need to select the manufacturer of your cable or satellite box, select IR control, and then continue with Step 6.

Step 4:
If you are using a cable or satellite box that supports serial control, you will get to a screen asking if you want to continue using IR control. Choose Yes continue using IR cable.

→ On the Channel Changing Setup screen, highlight Recommended Setup and press SELECT.

Continue with Step 5 - Step 10 below

→ If you are currently in Guided Setup, begin here:

Step 5:
Proceed until you see the Confirm IR Hookup screen. Select OK, I’m sure the IR cable is hooked up correctly.

Step 6:

If you are setting up the control for a cable box, you will see the Cable Channel Digits screen. Select the appropriate setting for your cable box. You may need to try changing channels on your cable box with the remote control that came with your cable box to find the correct setting.

→ You will now see the Cable “Enter” Button or Satellite “Enter” Button screen. Select the appropriate setting for your cable box. You may need to try changing channels on your cable box with the remote control that came with your cable box to find the correct setting.

Step 7:

The Channel Changing Tests screen is displayed next.

→ Read the instructions on this page and press SELECT.

Step 8:
Continue through each of the test screens. These screens allow your Nero LiquidTV™ to determine the best way to set up your cable or satellite box. Please be sure to answer the questions as accurately as possible.

→ If the tests are unsuccessful, follow the on-screen troubleshooting guide and then try the tests again.

Step 9:

If you are unable to find a code that works during the IR code tests, check the position of your IR by referring to How do I Verify My IR Cable Connections?.

NOTE: This information only applies to Nero manufactured hardware. Please contact your manufacturer if you need further help.